Folks,
I am in need of the dimensions or any information for the radio aerial mast system on the Bulldog. There are two wires that run from the rear spar to the top of the rudder. I have not found the mast picture or number in the Bulldog manual, but have found the socket number, but only need the diameter of the mast to make a socket that fits my rear spar. I would assume that these were generic RAF-AGS parts, but have not even found any information on that either.
Lastly would be information on the mast the sits behind the pilot. Again, still looking for numbers. Will trade a picture of you sitting in the Bulldog for said mast. (LOL, LOL)
Cheers,
Ed
By: Bulldogbuilder - 8th May 2016 at 16:30
Ed2,
That is AMAZING !!!! The last photo is fantastic. Everything you need to make one on the lathe. Thank you so very very very much!
Not to seem ungrateful in nay manner , does anyone know the height of the mast on the wing? I have already fabricated sockets that will be attached to the wing. all I can add is that the mast is steel, and round.
Thanks again for the time you spent on the photos and the drawing. (That dimensioned photo should become the “standard” method of such information.)
Ed1
By: powerandpassion - 7th May 2016 at 12:25
Where all the spikes from WW1 German helmets went…
Mate, here it is, nothing that couldn’t be lathed up :
[ATTACH=CONFIG]245763[/ATTACH]
[ATTACH=CONFIG]245764[/ATTACH]
[ATTACH=CONFIG]245765[/ATTACH]
[ATTACH=CONFIG]245766[/ATTACH]
Sign In
May 5, 2016 at 10:37 pm