some Part Numbers for you to get your teeth into :)

Recent Licenced Hurricane dig,
little 2″ thin brass disk numbers “A23824” ???

Recent Licensed Lancaster dig, panel door about 6″ x 4″ part number “0152642A” remains of black paint on it, the hinge for said panel is “A110514” with inspection stamp of “p.1 655, or could be 855. another fitting from the panel says in a circular inspection stamp “FHLR 32” and below it in a line the numbers “110352”

I know its a inspection panel of some type, but as for where on the aircraft I have not a clue, another clue is it has remains of black paint on it .

Lastly.. A load of little bits from a Recent Stirling Mrk1 Dig,

after cleaning some part numbers are shown as follows.

small aluminium strap with “B84547” on it.

small piece of cast alu, with various stamps on it “269 B M” ,overside stamped
“12918” and in smaller text , stamped “129187”

another piece which looks like a manifold gasket, all be it very heavy duty steel, reads “?B75353”

small clip with “AGS1613/ B ”

Brass 4 way air/hydraulic part with ” LFN96D/123 IV/A” on one side and A.M Stamp on other..

I dont think for a minute to get a response to this, But i thought if any of you are bored, and have a Idea, I would be chuffed to find out more about them, and where perhaps these bits were fitted to the aircraft, Total Long shot, But thought it a Worthy challenge for the forumites ,hope you dont mind me asking 🙂 😀