Sorry guys but another Spitfire question

Thanks very much Bruce.
You don’t fancy making a couple do you?!!!

Ken

No one does supply it; you will have to find the right id, and have the od turned down, and ground. That’s how I used to do it!

Yes, it’s is 1/32nd wall.

Bruce

Chumpy.
Thanks very much for that. I have looked for 1 5/16″ tube on internet but can’t find anyone who sells that diameter. It would have to be about a 1/32″ wall thickness if a 1 1/4″ tube has to pass through it. Any idea who could supply such tube?
Ken

It is 1-5/16″ diameter, as mentioned by Bruce two tubes one inside the other. The outer tube item 71, slid over a piece of 1-1/4″.

Jason.
Drawing no. Seems to be 30033/71.

What is the part number of the tube?

Regards

Jason

B*gger… I have a 3D drawing of the bearing but not the software to open it at moment..:apologetic:

Bruce.
I have a GA drawing but it doesn’t give the tube diameter. If I can find the diam. of the one that passes through the bearing then, with a bit of luck, I can work out the other sizes.
Regards

I don’t remember off hand, but there are two tubes, one within the other.