Spitfire firewall top curved cowling rail

Too easy!Yeah some of the drawings are hard to I.D. with the wording…Now find me a “Bracket”..LOL

Hi Steve,
Thought it was the fwd one on F5.Can send you a copy as well.PM your email addy 🙂

Hi Qldspitty, i was after a drawing for the fwd hoop that the fuel tank cover sits on. After a lot of searching have found the drawing, 36630-15 fwd boundry angle. Thanks anyway.

Steve.

Hi Steve,
Thought it was the fwd one on F5.Can send you a copy as well.PM your email addy 🙂

The forward angles attach the engine cowlings – the rear one is a one piece item with (with inward projecting brackets) which holds the tank armour and the fwd fastenings for the tank cover.

Hi Qldspitty,Is this the fwd boundry angle that the fuel tank cover attaches to ? If so where did you get the drawing from as i need a copy!

Cheers Steve

Hi Steve,
Thought it was the fwd one on F5.Can send you a copy as well.PM your email addy 🙂

.

Hello Tony, I’ve got a complete but, inevitably, distorted front armour plate which i’ll sort out measurements from if you need them. Or you could bring a big sheet of paper to Popham and draw around it.

What Mark old bean?For MkIX you need 36127-157-C Boundary angle.Can email it to you 🙂

Hi Qldspitty,Is this the fwd boundry angle that the fuel tank cover attaches to ? If so where did you get the drawing from as i need a copy!

Cheers Steve

got the washers…thanx for info on the wood bitz

on the way mate 🙂

Here is a pic of the mounts.We just turned them up out of Tassi Oak:p You need measurements for the firewall washers?

Full suit, or just the breastplate?

Don’t forget the armour plate that attaches to the back of this item.

cheers Steve…..I have the rear 1/2 moon thingy, but have not managed to acquire real armour yet…will prob have to get a drawing and make an MDF one as a starter!!

Unless anyone has some armour kicking around needing a deserving home!!???

Another drawing request!!? Please?! A nice chap has made me the curved L channel that takes the cowling fasteners and goes around the top (half moon shape). Anyway, I need to finish it (trim width and put in cowl fastener holes).

Don’t forget the armour plate that attaches to the back of this item.

Mk9 would do beautifully old chap! You chaps are so helpful down under, unlike some more locally that I could mention, but wont!!!:D

What Mark old bean?For MkIX you need 36127-157-C Boundary angle.Can email it to you 🙂