Key Publishing

saudiboyrick

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
May 1, 2016 at 7:52 pm in reply to: Propellor spinner identification #878177

saudiboyrick
Participant

I can’t seem to be able to load any photos from my phone but looking at a photo of a vickers viscount it is very similar and quite likely as I also picked up a huge spinner from a vickers viking from the same place. Shame about the photos as I have a cast alloy air scoop I need identifying also. It has BA37768 and A67754 in the casting. Would you have any idea about this?

May 1, 2016 at 3:50 pm in reply to: Propellor spinner identification #878309

saudiboyrick
Participant

Thanks for that. I will try to load some photos and will do a bit of research on the Dart

May 1, 2016 at 12:33 pm in reply to: Propellor spinner identification #878352

saudiboyrick
Participant

I will try but not sure how to on my phone as work blocks forums on my pc

May 19, 2015 at 10:11 am in reply to: Link Trainer – Is it worth the trouble #908156

saudiboyrick
Participant

Thanks for the info. It is quite a big piece and although I have plenty of room in my sheds it will obviously take up quite a bit of space. The crab is not with it as far as I know. I was planning to use it but only as a novelty in my small collection so still in 2 minds what to do. He has a fair amount of stuff so would I be better off putting the money towards a P&W R985 (£2500) or Anson propeller (£750) or Avro Lincoln nose gun turret with both .50 still attached (£3500)? Do these prices seem high or about right?

March 30, 2015 at 10:27 am in reply to: Help to identify propellers #865932

saudiboyrick
Participant

Hi, Yes, images 1 and 3 are the same as I had a bit of trouble loading the images and then deleted them all, 2nd attempt gave me 2 of the same and I didn’t want to have to go through it again. Apologies for that. The problem is that the blades are at my home in the UK and I am back at work in Saudi. They about 4 inches taller than me, hence guessing at 6′ at least
Below should be the image of the other one which is damaged.

March 30, 2015 at 9:45 am in reply to: Help to identify propellers #865952

saudiboyrick
Participant

No numbers that I could see. They stand around 6′ tall I would say. I have another as well that looks older as it has what looks like a crudely riveted leading edge copper looking strip but about the same length. I’m guessing the ‘B’ is relating to a balance weight? Thanks
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)